A disposable vape kit is made of many different parts, each of which holds almost equal importance. If one of them is missing, a vape device like m bar cannot function. Both vape devices are put together with similar parts. The only difference is that in the former, you cannot change or replace anything about them, while reusables are the opposite.
Summary of A Coil:
A coil is located in the atomiser of the vape device. It wraps around a wicking material, usually cotton. Vapours are produced when the battery gets into the action, and the coil heats the liquid soaked into the wicking material. That is why it is crucial that your wick is soaked in vape liquid.
Priming of Coils:
Those using vape devices for a while must have known of this term. It specifically relates to reusable devices since disposable vapes like Elux legend 3500 puffs and m bar contain auto-primed coils. If you are using a vape kit that allows you to change or replace its parts, you must pay attention to the priming part of the coil.
Priming of a coil is letting the e-liquid sit for enough time that allows the wicking material to saturate itself thoroughly before the coil gets heated. By doing this, you will be preventing dry hits, which are highly unpleasant. A dry hit occurs when the coil heats the wick but ends up burning it because there is not enough e-liquid soaked in it.
Time Required For Coil Saturation:
Priming does not take much time; it can be done within five to thirty minutes. It depends on certain factors; some of the simple and clear ones are:
- PG/VG ratio
- Coil type
- Coil resistance
More VG-concentrated e-liquids are viscous, so they require a little more time than usual. It is better to wait a few minutes to get an excellent vaping experience. In contrast, high-PG e-liquids will require less time for priming, and you can start taking puffs after letting the tank rest for a few minutes only.
The lower the resistance of the coil, the more attention it requires. Sub-ohm coils require more time to saturate because of the greater volume of the wicking material. Low-resistance coils are coupled with high-powered batteries for the best outcome. So, you need to make sure that the coil and wick are entirely soaked in the e-liquid. On the other hand, low-powered devices having a high-resistance coil can be primed quickly. But, if you find all this information overwhelming, you can use disposable vapes e.g. big fox vape as they are no maintenance devices.
How To Prime The Coil:
You can prime the coil by adding the e-liquid to your vape tank and then leave it unbothered for a few minutes, ranging from 5-30 minutes. It is best to keep your vape device upright, so the liquid soaks into the wick completely.
In such kits which allow you to remove the coil or separate the atomiser, you can directly add e-liquid to the coil through the holes present for airways. Even when you add the vape liquid to the coil directly, you should not use it right away after refilling the tank with e-juice. Leave it upright for a short while before using it.
Do Coils Require Saturation Before Each Puff:
The important thing to note is that priming is required only when you use the vape device for the first time. When you are done changing the coil, saturate it before using it; that is the only time you have to go through the priming process.
Afterwards, you do not need to give your device such a long time before you draw a puff. However, it is suggested to allow your vape kit a few seconds gap between each puff, whether it is a disposable vape or a reusable one. This is suggested so that you do not burn the coil sooner than possible and keep on enjoying your vaping experience in high spirits.